Traction Control System (TCL) - 2009.5

• General Description
  • Notes
  • Construction Diagram
• Traction Control System (TCL) Diagnosis
  • Introduction To Traction Control System (TCL) Diagnosis
    • TCL Diagnostic Trouble Code Detection Conditions
  • Troubleshooting Strategy
  • Diagnosis Function
    • How To Connect The Scan Tool (M.U.T.-III)
    • How To Read And Erase Diagnostic Trouble Codes
    • How To Read Data List
    • How To Perform Actuator Test
    • How To Diagnose The Can Bus Line
  • Diagnostic Trouble Code Chart
  • Diagnostic Trouble Code Procedures
    • C1396 Engine Torque Input Refusal
      • Notes
      • DTC Set Conditions
      • Troubleshooting Hints (The Most Likely Causes For This Code To Be Set Are:)
      • Diagnosis
    • C1397 Transmission Range Switch Input Refusal
      • Notes
      • DTC Set Conditions
      • Troubleshooting Hints (The Most Likely Causes For This Code To Be Set Are:)
      • Diagnosis
    • U1100 CAN Communications System Time Out Error Engine Related Data
      • Notes
      • DTC Set Condition
      • Troubleshooting Hints (The Most Likely Causes For These DTCS Are To Set Are:)
      • Diagnosis
    • U1101 CAN Communications System Time Out Error A/T Related Data
      • Notes
      • DTC Set Condition
      • Troubleshooting Hints (The Most Likely Causes For These DTCS Are To Set Are:)
      • Diagnosis
    • U1120 CAN Communications System TCL Uncontrollable by Engine Malfunction
      • Notes
      • DTC Set Condition
      • Troubleshooting Hints (The Most Likely Causes For These DTCS Are To Set Are:)
      • Diagnosis
    • U1400 Dynamic Range Error Accelerator Pedal Position Sensor
      • DTC Set Condition
      • Troubleshooting Hints (The Most Likely Causes For These DTCS Are To Set Are:)
      • Diagnosis
  • Symptom Chart
  • Symptom Procedures
    • INSPECTION PROCEDURE 1: When the Ignition Switch is Turned to the "ON" Position (Engine Stopped), the "TCL OFF" Indicator Light dose not Illuminate. INSPECTION PROCEDURE 2: When the Ignition Switch is Turned to the "ON" Position (Engine Stopped), the TCL Work Indicator Light dose not Illuminate. INSPECTION PROCEDURE 3: The "TCL OFF" Indicator Light Remains Illuminated After the Engine is Started. INSPECTION PROCEDURE 4: The TCL Work Indicator Light Remains Illuminated After the Engine is Started
      • Notes
      • Circuit Operation
      • Comment
      • Troubleshooting Hints
      • Diagnosis
    • INSPECTION PROCEDURE 5: When the TCL Switch is Push On, TCL dose not be Cancelled
      • Notes
      • Circuit Operation
      • Comment
      • Troubleshooting Hints
      • Diagnosis
    • INSPECTION PROCEDURE 6: TCL does not Operate
      • Comment
      • Troubleshooting Hints (The Most Likely Causes For This Case:)
      • Diagnosis
  • Data List Reference Table
  • Actuator Test Reference Table
  • Check At Abs/TCL-Ecu Terminal Voltage
    • Terminal Voltage Check Chart
    • Resistance And Continuity Between Harness-Side Connector Terminals
• Special Tools
• On-Vehicle Service
  • TCL Indicator Light Check
  • TCL Operation Check
  • TCL Switch Check
  • Wheel Speed Sensor Check
• TCL Switch
  • Removal And Installation
• Wheel Speed Sensor
  • Removal And Installation
• Abs/TCL-Ecu
  • Removal And Installation