Power Window Regulator Motor Assembly (Installed To The Front Side): Installation
NOTE:
The following procedure is for LH side. Perform the same procedures both for the LH side and RH side, unless otherwise specified.
- Installation of power window regulator motor assembly LH
- Using Torx socket wrench T25, with the 3 Torx screws, install the power window regulator motor assembly LH onto the front door window regulator RH.
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Using Torx socket wrench T25, with the 3 Torx screws, install the power window regulator motor assembly LH onto the front door window regulator RH.
- Installation of front door window regulator W/motor assembly (Refer to ADJUSTMENT )
- Installation of the front door frame sub-assembly RR LWR LH (Refer to ADJUSTMENT )
- Installation of front door glass sub-assembly LH (Refer to ADJUSTMENT )
- Adjustment of the front door glass sub-assembly LH
- Check the installation condition of front door glass. (Refer to ADJUSTMENT )
- Check the mounting condition of front door glass. (Refer to TRUNK PANEL )
- Installation of the front door service hole cover LH (Refer to ADJUSTMENT )
- Installation of power window regulator master switch assembly (with front armrest base panel UPR LH) (driver's side door) (Refer to ADJUSTMENT )
- Installation of power window regulator switch assembly (with front armrest base panel UPR RH) (passenger's side door) (Refer to ADJUSTMENT )
- Installation of the front door trim board sub-assembly LH (Refer to ADJUSTMENT )
- Installation of the door armrest cover LH (Refer to ADJUSTMENT )
- Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Power window registration settings (Refer to REGISTRATION SETTINGS )
- Function inspection of the power windows (Refer to UNIT INSPECTION )