Error code 14

ERROR CODE DESCRIPTION

Step	Inspection		Action
1	VERIFY POWER OUTER MIRROR FOLD/UNFOLD CONDITION Are the power outer mirrors unfolded?	Yes	Go to the next step.
1		No	Unfold the power outer mirrors, then go to the next step.
2	PERFORM SIDE CAMERA AIMING Perform the side camera aiming. Was the side camera aiming procedure completed correctly?	Yes	The side camera aiming is completed. Perform the 360° view monitor system screen display verification procedure. (See 360° View Monitor System Screen Display Verification Procedure ).
2		No	If error code 14 is displayed Go to the next step. If code other than error code 14 is displayed Go to the procedure for the displayed error code.
3	VERIFY DTCs Perform the DTC inspection. (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE (TYPE-A)] .) (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE (TYPE-B)] ). Is a DTC displayed?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (TYPE-A)] ). (See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (TYPE-B)] ).
3		No	If the side camera aiming is not completed correctly after performing the side camera aiming again, replace the 360° view monitor control module. (See 360° VIEW MONITOR SWITCH REMOVAL/INSTALLATION ).