Error code 09/0A/0B/0F/10

ERROR CODE DESCRIPTION

Step	Inspection		Action
1	VERIFY TARGET MARKER SETTING ENVIRONMENT AND POSITION Verify the following. The vehicle and target marker setting screen are set on level ground. The target marker is set to the position indicated in the aiming procedure. There is no dirt, cracks, damage, or wrinkling on the target marker. The area around the front camera or target marker is not shaded. There is no obstruction or moving object. The target marker has not moved or the target marker does not move during aiming. Display the screen of the 360° view monitor system in the center display by pressing the 360° view monitor switch. Does the target marker reflect light? Is there a malfunction?	Yes	Repair the malfunctioning location and go to the next step.
1		No	Go to the next step.
2	PERFORM FRONT CAMERA AIMING Perform the front camera aiming. Was the front camera aiming procedure completed correctly?	Yes	The front camera aiming is completed. Perform the 360° view monitor system screen display verification procedure. (See 360° View Monitor System Screen Display Verification Procedure ).
2		No	If error code 09/0A/0B/0F/10 is displayed Go to the next step. If code other than error code 09/0A/0B/0F/10 is displayed Go to the procedure for the displayed error code.
3	VERIFY DTCs Perform the DTC inspection. (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE (TYPE-A)] .) (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE (TYPE-B)] ). Is a DTC displayed?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (TYPE-A)] ). (See DTC TABLE [360°VIEW MONITOR CONTROL MODULE (TYPE-B)] ).
3		No	If the front camera aiming is not completed correctly after performing the front camera aiming again, replace the 360° view monitor control module. (See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION ).