Power Circuit Inspection

■ Open Or Short Check 

1. IG "OFF".
2. Disconnect ESC (ESP) switch harness connector.
3. IG "ON".
4. Measure voltage between power terminal of the ESC (ESP) switch harness connector and chassis ground.

   Specification:  Approx. B+

5. Is the measured value within specifications?

   YES 

   • Go to "SIGNAL CIRCUIT INSPECTION " Procedure.

   NO 

   • Check for open or blown fuse referring to "Circuit Diagram".
   • Repair open or short in power circuit and then, go to "SIGNAL CIRCUIT INSPECTION " procedure.