Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jaguar >> 2000 >> XJ8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Climate Control System - General Information) >> Climate Control System - General Information >> Inspection and Assembly Requirements - General Procedures

Inspection and Assembly Requirements - General Procedures

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Jaguar S-Type, 2007 Jaguar S-Type, 2006 Jaguar S-Type, 2005 Jaguar S-Type, and 2004 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check for leaks using ultraviolet (UV) Lamp. Refer to Fluorescent Dye Leak Detection - General Procedures .
    2. NOTE: Any time a hose or component connection leak is observed, the component and fitting must be separated, cleaned and a new O-ring fitted and lubricated with air conditioning compressor oil. Refer to Specifications .
    NOTE: When separating A/C joints, cap the open connections immediately. Do not leave open to atmosphere.
  2. O-ring seal surfaces must be free of dirt, lint, burrs and scratches. The O-ring and connector should be lubricated with air conditioning compressor oil. Refer to Specifications .
scientia non olet · About Mike's Workshop Manuals