Fluorescent Dye Leak Detection - General Procedures
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Jaguar S-Type, 2007 Jaguar S-Type, 2006 Jaguar S-Type, 2005 Jaguar S-Type, and 2004 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.
- Check for leaks using ultraviolet (UV) lamp.
- Check all components, fittings and lines of the A/C system.
- Carry out the repair. For additional information, refer to Air Conditioning article. .
- After the leak is repaired, remove any traces of leak trace dye with a general purpose oil solvent.
- Check the A/C system for correct operation.
- Verify the repair by operating the system for a short time and inspecting with the (UV) lamp.
WARNING:
Eye protection glasses supplied with the ultraviolet (UV) lamp should be used to protect eyesight from harm.
NOTE:
The air conditioning (A/C) system has an R-134a leak trace dye wafer incorporated into the desiccant bag. The exact location of leaks can be pinpointed by the bright yellow/green glow of the tracer dye. Since more than one leak may exist, always inspect each component. If it is necessary to add dye (due to a severe leakage for example) use proprietary tracer dye injection equipment.