Work Procedure

Always perform the BCI system action test to check that the system operates normally after replacing the side radar (left or right), or repairing any BCI system malfunction.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;

System description for BCI: Refer to System Description .
Handling precaution: Refer to Handling Precaution .
Normal operating condition: Refer to Symptom Description .

CHECK BCI SYSTEM SETTING
Check the sonar system operation. Refer to System Description .

>>

GO TO 2.
CHECK BCI SYSTEM SETTING
1. Start the engine.
2. Check that the BCI system setting can be enabled/disabled on the navigation screen.
3. Turn OFF the ignition switch and wait for 30 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
>>

GO TO 3.

ACTION TEST FOR BCI

Enable the setting of the BCI system on the navigation screen.

Check the BCI operation according to the following table.

Vehicle condition		Action	Indication on the combination meter	Buzzer
0 km/h (0 MPH) R range	If the radar detects an approaching vehicle from the side	Chime sound (single beep) Flashes Blind Spot Warning/Blind Spot Intervention indicator on the side of the approaching vehicle is detected Yellow rectangular frame appears in the display	Courtesy of NISSAN NORTH AMERICA, INC.	Single beep
	No approaching vehicle	No action	Courtesy of NISSAN NORTH AMERICA, INC.	-
	No approaching vehicle	BCI system OFF	Courtesy of NISSAN NORTH AMERICA, INC.	-

INSPECTION END