Work Procedure
- Always perform the distance sensor configuration after replacing the distance sensor.
- Always perform the radar alignment after removing and installing or replacing the distance sensor.CAUTION:
The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.
- Perform the FEB system action test to check that the FEB system operates normally.
- DISTANCE SENSOR CONFIGURATION
Perform the distance sensor configuration with CONSULT. Refer to Work Procedure .
>>
GO TO 2.
- PERFORM RADAR ALIGNMENT
Perform the radar alignment. Refer to Work Procedure .
>>
GO TO 3.
- FEB SYSTEM ACTION TEST
- Perform the following system action test.
- LDW: Refer to Work Procedure .
- LDP: Refer to Work Procedure .
- BSW: Refer to Work Procedure .
- Blind Spot Intervention: Refer to Work Procedure .
- TSR: Refer to Work Procedure .
- RCTA: Refer to Work Procedure .
- DAA: Refer to Work Procedure .
- Check that the each system operates normally.
>>
INSPECTION END
- Perform the following system action test.