ID Registration Without Transmitter Activation Tool
- With the ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the Data Link Connector (DLC). Turn ignition switch to ON position.
- Select "START (NISSAN BASED VHCL)".
- Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
- Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
- Adjust the tire pressure to the specified values for ID registration, and drive the vehicle at 25 mph (40 km/h) or more for a few minutes. See ID Registration Tire Pressure Specifications (2005) or ID Registration Tire Pressure Specifications (2006)
table.ID Registration Tire Pressure Specifications (2005)
Tire Position Tire Pressure - psi (kPa) Front Left 36 (250) Front Right 33 (230) Rear Right 30 (210) Rear Left 27 (190) ID Registration Tire Pressure Specifications (2006)Tire Position Tire Pressure - psi (kPa) Front Left 34 (240) Front Right 31 (220) Rear Right 29 (200) Rear Left 26 (180) - When ID registration of each wheel has been completed, a buzzer sounds as indicated and the hazard warning light flashes. See ID REGISTRATION ORDER SPECIFICATIONS table.
- After completing all ID registrations, press "END" to complete the procedure.
- Inflate all tires to specification.