Without HDS

WARNING: This page is about a different car, the 2011 Honda CR-V, 2010 Honda CR-V, 2009 Honda CR-V, 2008 Honda CR-V, and 2007 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.

Start the engine.
- If the engine does not start, go to the immobilizer system troubleshooting (see SYMPTOM TROUBLESHOOTING INFORMATION ).
- If the engine starts, go to step 2.
Press the transmitter lock or unlock button at least 10 times to reset the transmitter.
- If the locks work, the transmitter is OK.
- If the locks don't work, go to step 3.
Open the transmitter, and check for water damage.
- If you find any water damage, replace the transmitter and register the new transmitter.
- If there is no water damage, go to step 4.
  
  Fig 1: Identifying Transmitter
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Replace the transmitter battery (A) with a new one, and try to lock and unlock the doors with the transmitter by pressing the lock or unlock button at least 10 times.
- If the doors lock and unlock, the transmitter is OK.
- If the doors don't lock and unlock, go to step 5.
Fig 2: Identifying Transmitter Battery
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reprogram and register the transmitter (see IMMOBILIZER KEY REGISTRATION ), then try to lock and unlock the doors.
- If the doors lock and unlock, the transmitter is OK.
- If the doors don't lock and unlock, substitute a known-good transmitter and recheck (see IMMOBILIZER KEY REGISTRATION ). If still not operating, replace the immobilizer-keyless control unit (see IMMOBILIZER-KEYLESS CONTROL UNIT REPLACEMENT ).