Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2012 >> CR-Z Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (CVT) >> CVT >> General Troubleshooting Information >> Clear A/T DTCs Procedure

Clear A/T DTCs Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard.
    Fig 1: Locating Data Link Connector Component
    G06950870Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Turn the ignition switch to ON (II).
  3. Make sure the HDS communicates with the PCM. If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
  4. Clear the DTC(s) on the HDS screen.
scientia non olet · About Mike's Workshop Manuals