Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Honda >> 2007 >> Fit Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine Control System (1GR-FE)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE V-BANK COVER  (See REMOVAL  )
  3. REMOVE FAN SHROUD  (See REMOVAL )
  4. REMOVE GENERATOR ASSEMBLY  (See REMOVAL )
  5. SEPARATE COOLER COMPRESSOR ASSEMBLY 
    1. Remove the bolt, then separate the suction hose sub-assembly.
      Fig 1: Removing Bolt
      G05198003Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the cooler compressor assembly connector.
    3. Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
      Fig 2: Removing Bolts
      G05198004Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt, then remove the crankshaft position sensor.
      Fig 3: Removing Crankshaft Position Sensor Bolt
      G05198005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals