Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2005 >> Excursion 6.0 P, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Pinpoint Tests - 6.0L Diesel (99P F450/550) >> Pinpoint Test A: Vehicle Battery >> Introduction >> Fault Detection

Fault Detection

Vehicle power is monitored by the PCM. When the voltage is above or below a pre-calibrated value, an internal counter increments until a DTC is set.

CAUTION: The PCM harness connectors must be properly seated and the connector latch properly attached to eliminate possible driveability concerns or a no start condition. Installing the PCM connectors on an angle may cause an improper connection, misdiagnosis, and damaged components. Install the connector until the lever pivots and seats itself. Apply light pressure to get the connector into position on the PCM and then fully seat the connector.
NOTE: Visually inspect the harness connectors for corrosion, damage, proper mating, and correct pin tension.
scientia non olet · About Mike's Workshop Manuals