Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid/EV Controls System >> Repair Instructions >> Generator Control Module 3-Phase Cable Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Starter Generator Component Location
    GM4353331Courtesy of GENERAL MOTORS COMPANY
  1. Starter Generator (1) - Remove - Starter Generator Replacement 
    2. Fig 2: Heat Shield And Bolts
    GM4371958Courtesy of GENERAL MOTORS COMPANY
  2. Heat Shield Bolt (1) - Remove (Qty: 3)
  3. Heat Shield (2) - Remove
    4. Fig 3: Cover And Bolts
    GM4371972Courtesy of GENERAL MOTORS COMPANY
  4. Cover Bolt (2) - Remove (Qty: 2)
  5. Cover (1) - Remove
    6. Fig 4: Terminal Cover Seal And Dust Cover
    GM4371975Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Clean and inspect the seal for damage.

  6. Terminal Cover Seal (1) - Remove
  7. Dust Cover (2) - Remove
    8. Fig 5: Generator Control Module 3 Phase Cable Terminal Bolts
    GM4371976Courtesy of GENERAL MOTORS COMPANY
  8. Generator Control Module 3 Phase Cable Terminal Bolt (1) - Remove (Qty: 3)
    9. Fig 6: Generator Control Module 3-Phase Cable And Mounting Bolts
    GM4371978Courtesy of GENERAL MOTORS COMPANY
  9. Generator Control Module 3 Phase Cable Mounting Bolt (2) - Remove (Qty: 2)
  10. Generator Control Module 3 Phase Cable (1) - Remove
scientia non olet · About Mike's Workshop Manuals