Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2005 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Diagnostic Information And Procedures >> DTC 014 >> Test Description

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Tests the rear side door actuator control modules ability to provide power and ground to operate the power sliding door actuator motor.
  2. 3:  Tests the rear side door actuator control modules ability to provide power and ground to energize the power sliding door actuator clutch.
DTC 014

Step Action Yes No
Schematic Reference: Power Sliding Door (PSD) Schematics 
Connector End View Reference: Power Door Systems Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Disconnect the actuator motor connector to the rear side door actuator control module.
  2. Connect a test lamp across the actuator motor control circuit terminals from the rear side door actuator control module.
  3. Turn the power sliding door ON/OFF switch OFF to exit the on-board diagnostic modes.
  4. Manually close the power sliding door.
  5. Turn the power sliding door ON/OFF switch ON.
  6. Press the power sliding door OPEN/CLOSE switch.
Does the test lamp flash?		 Go to Step 3  Go to Step 6 
3 
  1. Disconnect the actuator clutch and door alarm connector to the rear side door actuator control module.
  2. Connect a test lamp across the actuator clutch high and low control circuit terminals from the rear side door actuator control module.
  3. Press the power sliding door OPEN/CLOSE switch.
Does the test lamp flash?		 Go to Step 4  Go to Step 6 
4 Inspect and if possible repair any damage to the actuator motor or actuator clutch pigtail harnesses or connectors. Refer to Wiring Repairs andConnector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 7  Go to Step 5 
5 Replace the actuator motor and clutch assembly. Refer to Motor Clutch Replacement - Power Sliding Door (With RPO E58)  or Motor Clutch Replacement - Power Sliding Door (With RPO E59) .
Is the repair complete?		 Go to Step 7  -
6 Replace the rear side door actuator control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Is the repair complete?		 Go to Step 7  -
7 Re-initialize the power sliding door and operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About Mike's Workshop Manuals