Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Volvo >> 2017 >> V60 Cross Country T5 >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Cables And Fuses - Removal, Replacement And Installation >> Connector Anti-Lock Braking System Module >> Connector Anti-Lock Braking System Module (Abs) [2015-2018] >> Assembly

Connector Anti-Lock Braking System Module (Abs) [2015-2018]: Assembly

NOTE:

Wheel sensor cables are twisted pair (positive and negative signal) cables for each wheel. It is important that paired cables are twinned in the same way when they are reinstalled in the connector. The cables must be twisted approximately 3 times per 100mm.

ASSEMBLING PRIMARY LOCK 

Check that the cable terminal is undamaged.

Press the cable terminal into the housing.

Check that the cable terminal is properly locked by pulling carefully on the cable.

ASSEMBLING SECONDARY LOCK 

Press the secondary lock into place.

scientia non olet · About Mike's Workshop Manuals