Diagnostic Trouble Code (DTC) Information ECM-U012D87
Condition
The Engine control module (ECM) regulates the alternator's charge voltage, via LIN communication, on the request of the Central electronic module (CEM), via CAN communication.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- No communication with the Alternator control module (ACM).
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Engine running.
NOTE:
The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.
Substitute Value
- The alternator control module (ACM) (charge regulator) charges with a fixed voltage.
Possible Source
- Contact resistance and oxidation in the terminals.
- Short-circuit between the LIN wiring.
- Open-circuit in the LIN wiring.
- Internal fault in another control module in the same part of the LIN network.
- Damaged alternator control module (ACM) (charge regulator).
Fault symptom[s]
- 1Q, Driving/Poor performance/lacks power/At take off
- AB, Starting/Engine hard to start/cranks slowly/Unsure when/at all times
- AJ, Driving/Poor performance/lacks power
- AK, Driving/Hesitates/surges/Unsure when/at all times
- AL, Driving/Hesitates/surges/During acceleration
- AM, Driving/Hesitates/surges/During deceleration
- BV, Driving/Hesitates/surges/At steady speed
- LM, 12 V main battery/Dead battery
- LN, 12 V main battery/Weak or low electrical power