Diagnostic Trouble Code (DTC) Information
WARNING: This page is about a different car, the 2007 Volvo XC90, 2006 Volvo XC90, 2005 Volvo XC90, 2004 Volvo XC90, and 2003 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.
Condition
NOTE:
The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).
The control modules in the car continually transmit and receive information over the data network (Controller Area Network).
Diagnostic trouble code (DTC) BCM-0097 is stored if the brake control module (BCM) registers that the signal from the central electronic module (CEM), which contains information about the vehicle type, has been absent for more than 27 seconds after the ignition is switched on.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.
Substitute Value
- Traction control is blocked
- Stability control is blocked
- Active yaw control is blocked.
HINT: For information about abbreviations, see BRAKE SYSTEM, ABBREVIATIONS .
Possible Source
- A brake control module (BCM) from another model has been installed
- A central electronic module (CEM) from another model has been installed.
Fault symptom[s]
- The anti-spin warning lamp is lit (up to and including 2002 model year)
- General yellow warning lamp lit (from model year 2003 inclusive)
- Anti-spin does not function
- The stability control system does not function
- The traction control system does not function.