Faulty Configuration: Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2013 Volvo C70, 2012 Volvo C70, 2011 Volvo C70, 2010 Volvo C70, and 2009 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

Ignition on
Wait for 20 seconds.
NOTE:
This first verification assumes that download of new software was required in the control module that generated the diagnostic trouble code. If download of new software was not required: read out diagnostic trouble codes and check if the code status is permanent or intermittent to learn how difficult it will be to find the fault.

Read out all diagnostic trouble codes.

Check that the diagnostic trouble code (DTC) for faulty communication is not stored again.

Use the VCT2000 (or appropriate scan tool) to read diagnostic trouble codes (DTCs).

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS CORPORATION

Has the fault been remedied?

YES
OKAY: Troubleshooting has been completed.
NO
Refer to TAKING READING ON CABLE IN THE CAN NETWORK (HS-CAN)

HINT: Once a fault has been repaired, conduct a verification to check that the fault has been remedied.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

Reinstall the connectors, components etc.
Ignition on
Erase diagnostic trouble codes (DTCs) in all control modules
Start the vehicle. Allow the vehicle to run for 10 minutes.
Read off diagnostic trouble codes (DTCs).

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS CORPORATION

Is the diagnostic trouble code for configuration fault regenerated?

YES
Refer to INFORMATION
NO
OKAY: Troubleshooting has been completed.