Removing The Level Sensor

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tie Straps Around Protective Sheath, Hoses And Wiring

Courtesy of VOLVO CARS CORPORATION

Remove:

-the tie straps around the protective sheath, hoses and wiring
the net protective sheath by carefully threading it off the hoses and wiring
the tie strap under the protective sheath.

Fig 2: Identifying Fuel Level Sensor Retaining Clips

Courtesy of VOLVO CARS CORPORATION

Remove:

the tie strap around the wiring above the pump
the level sensor by pressing in the two clips and pulling upwards
the thin pipe from the holder on the outside of the fuel tank unit
the wiring from the holder in the fuel tank unit.