Removing The Abs Hydraulic Modulator

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pipes To Wheel Brakes From ABS Hydraulic Modulator

Courtesy of VOLVO CARS CORPORATION

Disconnect the brake pipes to the wheel brakes from the ABS hydraulic modulator.

NOTE:

Note the position of the pipes in the hydraulic unit.

Hang the brake pipes on the cross member.

Plug the brake pipes and connections for the ABS hydraulic modulator and master cylinder.

Remove the connector from the control module.

Remove the 3 mounting screws for the bracket by the side member.

Raise the ABS hydraulic modulator and bracket.

Fig 2: ABS Hydraulic Modulator Bracket

Courtesy of VOLVO CARS CORPORATION

Remove:

the connector for the pump motor from the control module
the bracket from the ABS hydraulic modulator
the control module.