Vehicles With Fuel Pump Driver Module Located Under The Right-Hand Rear Bench Seat.: Notes

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Fuel Pump Driver Module

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Covers Over Seat Rails

Courtesy of VOLVO CARS CORPORATION

Remove:

covers over seat rails
the 4 screws

Lift out the seat on the right-hand side.

Fig 3: Installing A New Module

Courtesy of VOLVO CARS CORPORATION

Fold up the carpet. Detach the sill trim panel slightly.

Carefully lift up the insulation block and place a block under the insulation block to access the module.

Install the new module and connect the cable connector.

Remove the block and fold the carpet back. Press the sill trim panel into place.