Measures Upon Failed Destruction

Repeat activation for destruction and check the lamp on the box.

If the lamp lights  during activation, the connection has been properly made and the fuse in intact.

Remove the key from the discharge box and wait 20 minutes.

During that time, observe the SRS component so that no one comes within the destruction site.

After 20 minutes, check the connections of the SRS component.

Adjust the connections as necessary.

Repeat the destruction following the standard method.

If there is still no function, remove the key and disconnect the battery.

Wait another 20 minutes.

During that time, observe the SRS component so that no one comes within the destruction site.

Then detach the connection to the SRS component.

Remove the SRS component from the fixture.

Send the non-disarmed SRS component so it can be rendered harmless.

Ensure that local and national requirements are met.

If the lamp does not light  , check:

• that the battery is fully charged
• that all cables are properly connected
• that the fuse is intact.

Adjust the equipment as necessary.

Repeat the destruction following the standard method.

Upon continued failed destruction and indication of the indicator lamp, wait 20 minutes with continued attention paid to the that SRS component so that no one comes within 9 m of the SRS component.

Then detach the connection to the SRS component.

Check the equipment.