Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Volvo >> 2004 >> V70 Base, 2.4 64 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T (Aw50/51AWD) >> Adjustments >> Gear-Shift Position Sensor, Checking/Adjusting >> Checking The Setting

Checking The Setting

NOTE: When adjusting the gear-shift position sensor, press the tool down to the flat surfaces below the thread on the shaft.

Remove the lever. Install adjustment tool 999 5475 on the gear shift linkage rod. Check that the shaft is in the N position. The groove on the tool must align with the marking on the gear position sensor. If adjustment is required, see Adjusting The Gear-Shift Position Sensor .

scientia non olet · About Mike's Workshop Manuals