Specifications Index
SPECIFICATIONS INDEX - S40
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service Procedures | HVAC SYSTEMS - GENERAL SERVICING | ||
| Service Specifications | AC COMPRESSOR | ||
| Torque | TIGHTENING TORQUE | ||
| Axle Nut/Hub Nut | |||
| Torque | Tighten the screws for the hub alternately. First Step: tighten to 20 Nm Second Step: tighten to 65 Nm Third Step: angle-tighten to 60°
NOTE:
For information pertaining to angle-tightening, refer to SCREWED JOINT, TORQUE/ANGLE JOINT
|
||
| Battery | BATTERY MARKING | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | |||
| Service Specifications | WHEEL BRAKE - SPECIFICATIONS, MECHANICAL (544 BODY) | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Drive Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Thermostat R & I | COOLING SYSTEM - REMOVAL, REPLACEMENT AND INSTALLATION (544 BODY) | ||
| Water Pump R & I | COOLING SYSTEM - REMOVAL, REPLACEMENT AND INSTALLATION (544 BODY) | ||
| Engine Mechanical | |||
| Compression | NA | ||
| Oil Pressure @100 °C | ENGINE - SPECIFICATIONS, MECHANICAL (544 BODY) | ||
| Overhaul | ENGINE - SPECIFICATIONS, MECHANICAL (544 BODY) | ||
| Torque | ENGINE MECHANICAL AND TORQUE - SPECIFICATIONS, MECHANICAL (544 BODY) | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | |||
| Torque | 33 ft. lb (45 N. m) and then tighten an additional 65 degrees | ||
| Fuel System | |||
| Pressure Specification | Relative Pressure: 300 kPa, Absolute Pressure: 400 kPa | ||
| Checking Fuel Pressure | FUEL PRESSURE GAUGE | ||
| Fuel Filter R & I | |||
| FUEL SYSTEM - REMOVAL, REPLACEMENT AND INSTALLATION (544 BODY) | |||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plug | |||
| without Turbo | BOSCH FGR6NQE0 | ||
| with Turbo (T5) | BOSCH FR7MPP10 | ||
| Gap | without Turbo: 0.6 ± 0.1 mm with Turbo: 0.70 mm |
||
| Torque | 28 ± 3 Nm | ||
| Starting | |||
| Starter | STARTERS - FROM LATE PRODUCTION 2004 S40 | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel To Wheel Hub | Stage 1: 20 Nm Stage 2: 130 Nm |
||