Vehicles With Fuel Pump Module Originally Located On Fuel Tank
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
Replace the rear cable harness with a new one.
On the new cable harness there is an integrated connection to the control module.
Plug in the connector by the sill and the fuel pump.
Place the cable harness in the seal ring's slot and in the brackets on the body.
Install the floor hatch and tighten with 6 Nm.
Check carefully that the seal is in place when the hatch is installed.
The control module shall be placed in the spare wheel well's rear part on the right side, between the two markings and below the bead of sealing compound.
NOTE:
Use: Control Module 30769225
Remove the protective tape from the self-adhesive Velcro fastener and install the control module.
Plug in the cable's connector from the cable harness to the control module.