Removing The Control Module

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

Wait 2 minutes after the ignition has been switched off. The main relay must be voltage free before the control module is removed from the car. If the engine cooling fan (FC) runs on after the ignition has been switched off, wait until it stops and then wait for a further 2 minutes
Remove the cover over the control module box. Put the cover to one side.
NOTE:
Do not touch the control module terminal pins with your fingers. Static electricity may damage components in the control module.
Insert tool 9995722 around the control module
Move the upper section of the tool backwards as far as it will go. Pull up the tool
Carefully pull up the control module.