Installing front suspension components
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
HINT: Applies when installing front suspension components on both sides.
Install:
- a new M12 lock nut on the ball joint pinion. Counterhold the ball joint pinion while tightening so that the boot cannot turn. Tighten
- the anti-roll bar link. Use a new M10 lock nut. Counterhold the ball joint pinion while tightening so that the boot cannot turn. Tighten. See Summary of tightening torques for specific components . Tighten the drive shaft screw. Counterhold using a screwdriver in the brake disc vents. Tighten. See Summary of tightening torques for specific components
- the soundproofing over the drive shaft (applies to certain versions).