Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Volvo >> 2000 >> S40 >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Control - System & Component Testing - Except S40 & V40) >> Computerized Engine Controls >> Electronic Control Module (ECM) >> Connecting Breakout Box & Preliminary Check

Connecting Breakout Box & Preliminary Check

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 Volvo V70, 2000 Volvo S80, 2000 Volvo S70, 1999 Volvo V70, and 1999 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Wait 2 minutes. No voltage should be present at main relay before removing ECM. If cooling fan runs on after ignition is turned off, wait until 2 minutes after fan stops. Remove ECM box cover and lay aside.
    NOTE: DO NOT touch ECM pins. Static electricity can damage ECM components.
  2. Put ECM Removal Tool (999 5722) around ECM. Move upper section of tool backwards to stop and pull up on tool. Carefully pull up ECM. Ensure no pins or sockets are damaged. Press adapter down carefully into grooves inside ECM box. Press removal tool around adapter. Move upper section of tool forward to stop and pull up tool.
  3. Ensure terminals in ECM and ECM connector are secure and wiring to female terminals is secured to pins. Connect adapter to ECM connector (wiring side) and connect breakout box. To check power and ground circuits, see POWER CIRCUITS  and GROUND CIRCUITS  .
scientia non olet · About Mike's Workshop Manuals