Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Volvo >> 1976 >> 264 Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Fuel Delivery >> BOSCH Cis Fuel Injection - SAAB & VOLVO >> Testing >> Control Pressure Regulator

Control Pressure Regulator

  1. Unplug connector at control pressure regulator. With voltmeter, check for 11.5 volts at wiring harness connector. On 1975-77 models, disconnect air sensor connector and positive wire at alternator (Volvo only).
  2. On 1978-79 Volvo, connect Test Relay (5170) to ignition coil. On 1978-79 Saab, connect jumper wires to fuel pump circuit and remove positive wire at alternator.
  3. On all models, connect ohmmeter between positive terminal on control pressure regulator and ground. If ohmmeter reads infinity, replace control pressure regulator.
scientia non olet · About Mike's Workshop Manuals