Axle Alignment Procedure: Notes
The following sequence of procedure steps must be observed.
NOTE:
The vehicle must only be measured at curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Note the information in the alignment equipment.
Measuring procedure
| Start | → | Perform wheel run-out compensation. | → | Bounce the vehicle | ||||||
| ↓ | ||||||||||
| Turn the steering wheel into the straight ahead position and secure it. Refer to (1). | ← | Height, Measuring. Refer to Height, Measuring . | ← | Insert the Brake Pedal Actuator:V.A.G 1869/2 . | ||||||
| ↓ | ||||||||||
| Check camber at front axle | → | Is the actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjusting. Refer to FRONT AXLE CAMBER, ADJUSTING . | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check rear axle camber | → | Is the actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjusting. Refer to REAR AXLE CAMBER, ADJUSTING . | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check toe at rear axle | → | Is the actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Adjusting. Refer to REAR AXLE CAMBER, ADJUSTING . | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check caster at front axle | → | Is the actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | Yes | Check the axle components and assembly | ||||||
| ↓ | ↓ | |||||||||
| ↓ | ← | ← | ← | ← | ← | |||||
| ↓ | ||||||||||
| Check toe at front axle | → | Is the actual value within tolerance? | → | No | ||||||
| ↓ | ↓ | |||||||||
| End | ← | Yes | Adjusting. Refer to FRONT AXLE TOE, ADJUSTING . | |||||||
| ↑ | ↓ | |||||||||
| ↑ | ← | ← | ← | ← | ← | |||||
|
||||||||||