Heater And A/C Unit, Removing And Installing: Notes
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, 2016 Volkswagen Jetta, and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Hose Clamps - Up To 25 mm :3094
- Torque Wrench 1331 5-50Nm :VAG1331
- Engine Bung Set :VAS6122
- Shop Crane - Drip Tray :VAS6208
- A/C Service Station :VAS6007A (or succeeding model)
- Compressed air gun
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- O-rings - Refrigerant lines
NOTE:
The removal and installation of the heater and A/C unit for vehicles with an A/C system (with manual control) and Climatronic (A/C system with automatic control) is done the same.
Depending on the engine and vehicle version, it may be necessary to loosen or to remove the following components: upper engine cover, compressed air pipe to throttle valve part and, depending on the engine, the intake manifold, etc.