Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Volkswagen >> 2021 >> Arteon SEL R-Line, AWD >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Motor Systems >> Engine Assembly >> 10 Engine Assembly >> Assembly Mounts >> Transmission Mount, Removing And Installing >> Installing

Transmission Mount, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts. Push the rear of the transmission upward using a floor jack if necessary.

-- Secure the transmission support to the longitudinal member.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Position the bolts by hand. While doing so, make sure that the bolts are not installed crooked.

-- Check the adjustment of the subframe mount. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .

-- When the bolts are tightened to the tightening specification, remove the :10 - 222 A  from the engine.

scientia non olet · About Mike's Workshop Manuals