3.2.1 Adaptive Cruise Control Module, Removing And Installing, With Retaining Plate
Special Tools And Workshop Equipment Required
- Torque Wrench 1410 - VAG1410-
NOTE:
If the Distance Regulation Control Module - J428- is replaced, call up the respective function using the Vehicle Diagnostic Tester.
Removing
- Remove the bolts -1-.
- Remove the Distance Regulation Control Module - J428- with retaining plate -3-.
- Disconnect the connector -2-.
Installing
Install in the reverse order of removal. Note the following:
- Calibrate the adaptive cruise control. Refer to 3.3 Adaptive Cruise Control, Calibrating
Tightening Specifications