Gaskets, O-Rings And Seals
- Thoroughly clean the separation surfaces and apply sealing paste AMV 188 200 03.
- Apply the sealing paste evenly and not too thick.
- Replace gaskets and oil seals.
- After removing gaskets, examine the contact surface on the housing/shaft for burrs resulting from removal or for other signs of damage.
- Before installing the radial shaft seals, lightly lubricate the outer circumference and fill the space between the sealing lips halfway with sealing grease for seal G 052 128 A1 -arrow-.
Courtesy of VOLKSWAGEN UNITED STATES, INC.
- The open side of the seals point toward the fluid to be sealed in.
- Check the transmission fluid level. Refer to TRANSMISSION FLUID, CHECKING
.
- Lightly lubricate O-rings before installing to prevent them from being crushed when installing.