Engine Mount Adjustment, Checking

• There must be at least 10 to 13 mm (0.4 to 0.5 inch) -a- between the engine mount bracket -2- and the right longitudinal member.
  Fig 1: Identifying Casting Edge On Engine Support Location

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
• The casting edge on the engine mount bracket -2- must be parallel to the engine mount support arm -1-, dimension -x- must be the same at the front and at the rear.

Only if there is a noise (the engine or transmission is hitting the longitudinal member when driving around a curve) and dimension -a- is not within 10 to 13 mm:

-- Adjust the engine mount, refer to ENGINE AND TRANSMISSION MOUNT, ADJUSTING .