P129E - Inverter Control Circuit Overcurrent: Notes
For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAM.
- >>When Monitored:<< With the ignition ON and the battery voltage greater than 10.4 volts.
- >>Set Condition:<< An overcurrent condition is detected in the inverter control output circuit.
| Possible Causes |
|---|
| TERMINAL DAMAGE OR CORROSION |
| INVERTER CONTROL OUTPUT CIRCUIT P805 SHORT TO GROUND |
| INVERTER MODULE |
| TOTALLY INTEGRATED POWER MODULE |
For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAM.
- >>When Monitored:<< With the ignition on. Battery voltage greater than 10.4 volts.
- >>Set Condition:<< An overcurrent condition is detected in the (P805) Inverter Enable Switch Signal circuit.
| Possible Causes |
|---|
| TERMINAL DAMAGE OR CORROSION |
| (P805) INVERTER ENABLE SWITCH SIGNAL CIRCUIT SHORTED TO GROUND |
| INVERTER MODULE |
| TOTALLY INTEGRATED POWER MODULE (TIPM) |