2.0L - Generic Scan Tool - Engine Code: CBFA (Sedan)

• St Generic Scan Tool
  • General Information
    • Notes
    • Safety Precautions
    • Clean Working Conditions
    • On Board Diagnostic Systems
    • Malfunction Indicator Lamp Illumination
    • Controller Area Network Data Link
    • Electronic Power Control Warning Lamp
  • Description And Operation
    • Notes
    • Fuel Supply System
    • Evaporative Emission System
    • Electronic Engine Power Control
    • Fuel Injection System
    • Engine Control Module
    • Exhaust System Components
    • Secondary Air Injection System
    • Ignition System
    • Automatic Transmission
  • Diagnosis And Testing
    • Preliminary Check
    • Readiness Code
    • Diagnostic Modes 01 - 09
      • Notes
      • Diagnostic Mode 01 - Read Current System Data
      • Diagnostic Mode 02 - Read Operating Conditions
      • Diagnostic Mode 03 - Read DTC Memory
      • Diagnostic Mode 04 - Erase DTC Memory
      • Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions
        • Notes
        • Monitor-ID $01: Oxygen Sensor Monitor Bank 1 - Sensor 1
        • Monitor-ID $02: Oxygen Sensor Monitor Bank 1- Sensor 2
        • Monitor-ID $03: Oxygen Sensor Monitor Bank 1 - Sensor 3
        • Monitor-ID $21: Catalytic Converter Monitoring
        • Monitor-ID $35: Camshaft Adjustment / I V V T Bank 1
        • Monitor-ID $3A: Fuel Tank EVAP System Integrity/Leak Test (0.90")
        • Monitor-ID $3B: Fuel Tank EVAP System Integrity/Leak Test (0.40/1.0mm)
        • Monitor-ID $3C: Fuel Tank EVAP System Integrity/Leak Test (0.20/0.5mm)
        • Monitor-ID $3D: EVAP Valve Function Check
        • Monitor-ID $41: Oxygen Sensor Heater Monitor Bank 1 - Sensor 1
        • Monitor-ID $42: Oxygen Sensor Heater Monitor Bank 1 - Sensor 2
        • Monitor-ID 43: Oxygen Sensor Heater Monitor Bank 1 - Sensor 3
        • Monitor-ID $71: Secondary Air Injection System
        • Monitor-ID $A2: Mis-Fire Cylinder 1 Data
        • Monitor-ID $A3: Mis-Fire Cylinder 2 Data
        • Monitor-ID $A4: Mis-Fire Cylinder 3 Data
        • Monitor-ID $A5: Mis-Fire Cylinder 4 Data
      • Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle
      • Diagnostic Mode 08 - Request Control Of On-Board System, Test Or Component
      • Diagnostic Mode 09 - Read Vehicle Information
    • DTC Tables
    • Transmission DTC Tables
    • Diagnostic Procedures
      • Fuel Pump Electrical, Testing
      • Fuel Pressure Test
      • Fuel Pump Delivery Quantity, Checking
      • Fuel Pressure Sensor, Checking
        • Notes
        • Checking wiring
        • Check reference signal
      • Fuel Pressure Regulator Valve, Checking
      • EVAP System, Checking For Leaks
      • Evaporative Emission Canister System, Checking For Proper Seal
      • Evaporative Emission Canister Purge Regulator Valve Checking
        • Notes
        • Check Ground activation
      • Leak Detection Pump Checking
      • Accelerator Pedal Position Sensor / Accelerator Pedal Position Sensor 2 Checking
      • Throttle Valve Control Module -J338-, CHECKING
      • Turbocharger Recirculating Valve Checking
      • WASTEGATE Bypass Regulator Valve, Checking
      • Charge Air Pressure Sensor, Checking
        • Notes
        • Checking wiring
        • Check reference signal
      • Heated Oxygen Sensor Before Catalytic Converter, Checking
      • Heated Oxygen Sensor Heater Before Catalytic Converter, Checking
      • Heated Oxygen Sensor 2 Before Three Way Catalytic Converter, Checking
      • Heated Oxygen Sensor 2 Heater Before Three Way Catalytic Converter, Checking
      • Heated Oxygen Sensor After Three Way Catalytic Converter, Checking
      • Heated Oxygen Sensor Heater After Three Way Catalytic Converter, Checking
      • MAF Sensor, Checking
        • Notes
        • Checking wiring
      • Engine Coolant Temperature Sensor 1 Or 2 Checking
        • Notes
        • Testing if display is approx. - 40.0° C
        • Testing if display approx. 140.0 °C
      • Intake Air Temperature Sensor, Checking
        • Notes
        • Testing if display approx. -40° C or approx. -46° C:
        • Testing if display approx. 140° C:
      • Ambient Air Temperature Sensor, Checking
      • Engine Speed Sensor, Checking
      • Fuel Injectors, Checking
      • Intake Manifold Runner Control Valve, Checking
      • Intake Manifold Runner Position Sensor, Checking
        • Notes
        • Checking wiring
        • Check reference signal
      • Voltage Supply, Checking
      • Speed Signal, Checking
      • Three Way Catalytic Converter, TWC Checking
      • Combination Valve, Checking
      • Secondary Air Injection Pump Relay, Checking
        • Notes
        • If Injection Pump Did Operate and Run
      • Secondary Air Injection Pump Motor, Checking
      • Secondary Air Injection Solenoid Valve, Checking
      • Secondary Air Injection Sensor 1, Checking
        • Notes
        • Checking wiring
        • Checking Activation
      • Camshaft Position Sensor, Checking
        • Notes
        • Checking wiring
        • Checking Activation
      • Camshaft Adjustment Valve 1, Checking
      • Knock Sensor 1, Checking
        • Notes
        • Checking wiring
        • Check reference signal
      • Ignition Coils With Power Output Stage, Checking
      • Can-Bus Terminal Resistance, Checking
      • Can-Bus Terminal Resistance, TCM To ECM, Checking
      • Lin-Bus Circuit, Checking