Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch [09/2022 - ]: Procedure

1. Using the GTS, read the data for the condition when the power window regulator switch assembly was operated.

   Body Electrical > P-Door Motor > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   P Door P/W Auto SW	Front passenger door power window auto switch signal	OFF or ON	OFF: Front passenger door power window auto switch not being operated ON: Front passenger door power window auto switch being operated	-

   Body Electrical > P-Door Motor > Data List 

   Tester Display
   P Door P/W Auto SW

   OK

   On the GTS screen, ON or OFF is displayed accordingly.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  3

Result: 

OK 

See step  2

1. Initialize the front power window regulator motor assembly RH.

   Refer to INITIALIZATION [09/2022 - ]

   OK

   Power window system operates normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH. Refer to  REMOVAL [09/2022 - ] 

Refer to INSPECTION [09/2022 - ]

Result

Result: 

NG 

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY. Refer to  REMOVAL [09/2022 - ] 

Result: 

OK 

See step  4

1. Disconnect the K6 power window regulator switch assembly connector.
2. Disconnect the K8 front power window regulator motor assembly RH connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K8-4 (AUTO) - K6-8 (AUTO)	Always	Below 1 Ω
   K8-4 (AUTO) or K6-8 (AUTO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH. Refer to  REMOVAL [09/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR