Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of ECM | Update ECU security key | Vehicle Control History (RoB) are stored | Refer to UPDATE ECU SECURITY KEY [06/2024 - ] |
| Perform Vehicle Identification Number (VIN) registration | DTC is output | Refer to REGISTRATION [06/2024 - ] | |
| Replacement of engine coolant temperature sensor | Inspection after repair |
|
Refer to INITIALIZATION [06/2024 - ] |
| Replacement of inverter with converter assembly | Resolver learning |
|
Refer to UTILITY [06/2024 - ] |
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
| Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| Front camera system | Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. | Refer to INITIALIZATION [06/2024 - ] |
LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY
| Effect/Inoperative Function when Necessary Procedure not Performed | Necessary Procedure | Link |
|---|---|---|
| Power back door system | Fully close the back door by hand. Initialization is not necessary if the above procedures are performed while the back door is closed. |
Refer to INITIALIZATION [06/2024 - ] |
| Air conditioning system | After the ignition switch is turned to ON, the servo motor standard position is recognized. | - |
