Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2025 >> 4Runner TRD Pro >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - Service Information >> Camshaft Oil Control Valve >> On-Vehicle Inspection [12/2024 - ] >> Procedure

On-Vehicle Inspection [12/2024 - ]: Procedure

  1. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 

    HINT: 

    Refer to REMOVAL [12/2024 - ] 

  2. INSPECT INTAKE CAMSHAFT TIMING GEAR BOLT ASSEMBLY 
    1. Check the stroke of the plunger in the center of the intake camshaft timing gear bolt assembly.

      Standard Stroke

      Specified Condition Result
      2.2 mm or higher
      0.0866 in. or higher      		 mm
      in.

      If the result is not as specified, replace the intake camshaft timing gear bolt assembly.

      GTY1077537Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Plunger
  3. INSPECT EXHAUST CAMSHAFT TIMING GEAR BOLT ASSEMBLY 
    1. Check the stroke of the plunger in the center of the exhaust camshaft timing gear bolt assembly.

      Standard Stroke

      Specified Condition Result
      2.2 mm or higher
      0.0866 in. or higher      		 mm
      in.

      If the result is not as specified, replace the exhaust camshaft timing gear bolt assembly.

      GTY1076191Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Plunger
  4. INSTALL CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 

    HINT: 

    Refer to INSTALLATION [12/2024 - ] 

scientia non olet · About Mike's Workshop Manuals