Installation [10/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
1. Install the rear height control sensor sub-assembly with the 2 bolts and nut.
  Bolt
  
  Torque: 13.5 N.m (138 kgf/cm, 10 ft.lbf)
  
  Nut
  
  Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
2. Engage the clamp.
3. Connect the connector.
INSTALL REAR WHEEL LH
Refer to PROCEDURE - Step 1 [09/2014 - 10/2022] , or refer to PROCEDURE - Step 2 [10/2022 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2018 - 09/2020] , or refer to INITIALIZATION [09/2020 - 10/2022] , or refer to INITIALIZATION [10/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]
INITIALIZE HEIGHT CONTROL SENSOR SIGNAL
Refer to INITIALIZATION [10/2018 - ]
ADJUST HEADLIGHT AIMING
Refer to ADJUSTMENT [10/2018 - ]