Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2023 >> Sequoia TRD Pro >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Navigation System - Service Information) >> Multi-Display >> Reassembly [09/2014 - 11/2017] >> Procedure

Reassembly [09/2014 - 11/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FRONT ESCUTCHEON 
    1. Engage the 3 claws and 2 guides as shown in the illustration.
      GTY646164Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 5 guides and 10 claws as shown in the illustration.
      GTY646166Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Check that there is no clearance between the front escutcheon and rear escutcheon as shown in the illustration.

      Standard Measurement

      Area Measurement
      A 0 mm (0 in.)
      B 0 mm (0 in.)
      GTY635884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the front escutcheon and rear escutcheon with the 6 screws.
      GTY679916Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the release paper from a new insulator.

      HINT: 

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    6. Install the insulator as shown in the illustration.
      GTY614505Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Standard Measurement

      Standard Measurement

      Area Measurement
      A 0 to 2.0 mm (0 to 0.0787 in.)
      B 0 to 2.0 mm (0 to 0.0787 in.)
scientia non olet · About Mike's Workshop Manuals