Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2023 >> Sequoia TRD Pro >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Navigation System - Service Information) >> Multi-Display >> Installation [09/2014 - 11/2017] >> Procedure

Installation [09/2014 - 11/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL MULTI-DISPLAY ASSEMBLY 
  2. INSTALL NO. 1 MULTI-DISPLAY BRACKET 
    1. Install the No. 1 multi-display bracket with the 2 screws.
  3. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET 
    1. Engage the clamp.
    2. Connect each connector.
    3. Push the multi-display assembly with bracket as shown in the illustration to engage the 4 clips.
      GTY501179Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the multi-display assembly with bracket with the 2 bolts.
  4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 13

  5. INSTALL METER HOOD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 31

  6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 34

  7. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 35

  8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 36

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2014 - 10/2015] , or refer to INITIALIZATION [10/2015 - 11/2017]

  10. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column) 

    Refer to PROCEDURE - Step 17

scientia non olet · About Mike's Workshop Manuals