Inspection [10/2024 - ]: Procedure
- INSPECT PATTERN SELECT SWITCH ASSEMBLY
- Check the resistance between SPORT MODE switch terminals.
*a Component without harness connected
(Pattern Select Switch Assembly)Standard Resistance
Terminal No. Inspection conditions Standard 4 - 8 Switch OFF 1 MΩ or more 4 - 8 Switch ON Less than 1 Ω If the result is not as specified, replace the pattern select switch assembly.
- Check the illumination condition by applying the battery voltage between the illumination terminals.
*a Component without harness connected
(Pattern Select Switch Assembly)Standard
Terminal No. Inspection conditions Judgment standards 2 (+) - 3 (-) Apply battery voltage Light ON NOTE:- When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
- Incorrect polarity connection may cause LED damage inside the switch.
If the result is not as specified, replace the pattern select switch assembly.
- Check the resistance between SPORT MODE switch terminals.