Removal [04/2024 - ]: Procedure
- DRAIN ENGINE COOLANT
Refer to PROCEDURE - Step 1
- REMOVE ENGINE COOLANT TEMPERATURE SENSOR (for Outlet Side) NOTE:
If the engine coolant temperature sensor has been struck or dropped, replace it.
- DISCONNECT WIRE HARNESS
HINT:
Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.
- DISCONNECT NO. 2 INTERCOOLER COOLING WATER PIPE
HINT:
Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.
- DISCONNECT NO. 1 INTERCOOLER COOLING WATER PIPE
HINT:
Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.
- REMOVE ENGINE COOLANT TEMPERATURE SENSOR (for Water Inlet Housing Side) NOTE:
If the engine coolant temperature sensor has been struck or dropped, replace it.
- REMOVE INTAKE MANIFOLD WITH INTERCOOLER ASSEMBLY
HINT:
Perform this procedure only when replacement of the engine coolant temperature sensor (for Cylinder Block Side) is necessary.
Refer to REMOVAL [12/2022 - ]
- REMOVE ENGINE COOLANT TEMPERATURE SENSOR (for Cylinder Head Side)
- Disconnect the engine coolant temperature sensor connector.
- Using SST, remove the engine coolant temperature sensor from the cylinder head assembly.
- SST: 09817-33191
NOTE:If the engine coolant temperature sensor has been struck or dropped, replace it.
- Remove the gasket from the engine coolant temperature sensor.