Installation [10/2022 - ]: Procedure
- INSPECT SPIRAL CABLE SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
- INSTALL STEERING SENSOR
- Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
*a Guide *b Pin *c Lock Pin NOTE:- Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
- Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.
- The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.
- Remove the lock pin from the steering sensor.
- Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
- INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
- INSTALL UPPER STEERING COLUMN COVER
Refer to PROCEDURE - Step 12
- INSTALL LOWER STEERING COLUMN COVER
Refer to PROCEDURE - Step 13
- ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
- INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
- INSTALL STEERING WHEEL ASSEMBLY
Refer to PROCEDURE - Step 5
- INSTALL HORN BUTTON ASSEMBLY
Refer to PROCEDURE - Step 1
- INSTALL LOWER NO. 3 STEERING WHEEL COVER
Refer to PROCEDURE - Step 2
- INSTALL LOWER NO. 2 STEERING WHEEL COVER
Refer to PROCEDURE - Step 3
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSTALL BATTERY HOLE COVER
Refer to PROCEDURE - Step 57
- INSTALL REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 4
- UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [07/2020 - ]
- INSPECT HORN BUTTON ASSEMBLY
- Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
Refer to PROBLEM SYMPTOMS TABLE [07/2020 - ]
- Make sure that the horn sounds.
- PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [07/2020 - ]
- INSPECT SRS WARNING LIGHT
Refer to OPERATION CHECK [10/2022 - ]
- CHECK STEERING WHEEL CENTER POINT
- CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Refer to PROCEDURE - Step 19
- INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Refer to WORK PROCEDURE [10/2022 - ]
HINT:
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.