Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2021 >> Venza LE >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System - Service Information >> Rear Speed Sensor >> Installation [07/2020 - ] >> Procedure

Installation [07/2020 - ]: Procedure

  1. INSTALL REAR SKID CONTROL SENSOR 
    1. Install the rear skid control sensor to the rear axle carrier sub-assembly with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

      NOTE:
      • Keep the tip of the rear skid control sensor and installation hole free of foreign matter.
      • Firmly insert the rear skid control sensor body into the rear axle carrier sub-assembly before tightening the bolt.
      • After installing the rear skid control sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear skid control sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.
    2. Connect the parking brake wire assembly connector to the rear skid control sensor.
  2. INSTALL REAR WHEEL 

    Refer to INSTALLATION [07/2020 - ]

  3. PERFORM INITIALIZATION AND CALIBRATION 

    Refer to CAUTION / NOTICE / HINT  Refer to CAUTION / NOTICE / HINT 

  4. CHECK FOR SPEED SENSOR SIGNAL 

    Refer to SIGNAL CHECK [07/2020 - ]

scientia non olet · About Mike's Workshop Manuals