Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2021 >> Tacoma TRD Pro, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FKS) - Service Information >> Accelerator Pedal >> On-Vehicle Inspection [08/2015 - ] >> Procedure

On-Vehicle Inspection [08/2015 - ]: Procedure

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.
    5. When depressing or releasing the accelerator pedal, check that the values of Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage are within the specification.

      Standard Voltage

      Item Condition Specified Condition
      Accelerator Position Sensor No. 1 Voltage Released 0.5 to 1.1 V
      Depressed 2.6 to 4.5 V
      Accelerator Position Sensor No. 2 Voltage Released 1.2 to 2.0 V
      Depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.

scientia non olet · About Mike's Workshop Manuals